Abstract
Introduction: The effects of different physical activation agents on carbon material pore development and the subsequent methane adsorption were studied.
Methods: Palm Kernel Shell (PKS) as a carbon precursor was pre-treated with ZnCl2 and activated for two hours with (i) CO2, (ii) steam, and (iii) the combination of CO2 and steam (in series).
Results: The findings indicate that the combination of two activation agents in series resulted in a considerably high value of methane uptake of 118.73 V/V at 10 bar. Compared to the activation with a single activating agent (steam or CO2), double activation agents produced Activated Carbon (AC) with a higher BET surface area of 869.8 m2/g and a total pore volume of 0.47 cm3/g. The obtained carbon materials were predominantly microporous, with 92.08% micropores and 7.92% mesopores, respectively.
Conclusion: The results show that combining two activation agents with different diffusivity and reactivity significantly affects carbon pore development for methane adsorption.
Keywords: Adsorbent, palm kernel shell, activated carbon, methane adsorption, porosity, mesopores.
Graphical Abstract
[http://dx.doi.org/10.15255/KUI.2020.077]
[http://dx.doi.org/10.1016/j.scitotenv.2020.141094] [PMID: 32745853]
[http://dx.doi.org/10.1260/0263-6174.32.8.681]
[http://dx.doi.org/10.1016/j.jece.2020.103910]
[http://dx.doi.org/10.1007/s11814-016-0072-z]
[http://dx.doi.org/10.1149/1.2426447]
[http://dx.doi.org/10.1016/0008-6223(75)90026-3]
[http://dx.doi.org/10.1016/S0167-2991(08)63064-5]
[http://dx.doi.org/10.1351/pac200779030293]
[http://dx.doi.org/10.1515/revce-2017-0113]
[http://dx.doi.org/10.1016/j.apsusc.2005.11.029]
[http://dx.doi.org/10.2174/2405520411666180427112212]
[http://dx.doi.org/10.1016/j.cej.2019.06.031]
[http://dx.doi.org/10.1016/j.jclepro.2018.11.094]
[http://dx.doi.org/10.1016/j.micromeso.2007.04.046]
[http://dx.doi.org/10.1016/j.coal.2013.01.001]
[http://dx.doi.org/10.1016/j.fuel.2020.119254]
[http://dx.doi.org/10.1016/j.biombioe.2018.04.015]
[http://dx.doi.org/10.1016/j.fuproc.2007.11.030]
[http://dx.doi.org/10.1016/j.crci.2014.05.006]
[http://dx.doi.org/10.1080/10962247.2018.1460282] [PMID: 29667515]
[http://dx.doi.org/10.1088/1757-899X/105/1/012027]
[http://dx.doi.org/10.3390/ma9070565] [PMID: 28773684]
[http://dx.doi.org/10.1006/jcis.2000.7171] [PMID: 11071731]
[http://dx.doi.org/10.1021/acs.iecr.5b01589]
[http://dx.doi.org/10.1016/j.proeng.2016.06.463]
[http://dx.doi.org/10.1016/j.cherd.2011.10.001]
[http://dx.doi.org/10.1002/jctb.712]
[http://dx.doi.org/10.1016/j.micromeso.2006.11.024]
[http://dx.doi.org/10.1016/j.micromeso.2011.11.040]