Login Register Cart 0
Generic placeholder image

Recent Advances in Electrical & Electronic Engineering

Editor-in-Chief

ISSN (Print): 2352-0965
ISSN (Online): 2352-0973

Back
Journal Home About Journal Editorial Board Journal Insight Current Issue Volumes/Issues
Subscribe
Research Article

A Novel Fault-location Method for HVDC Transmission Lines Based on Concentric Relaxation Principle and Wavelet Packet

Author(s): Congshan Li*, Ping He, Feng Wang, Cunxiang Yang, Yukun Tao and Yuqi Ji

Volume 13, Issue 5, 2020

Page: [705 - 716] Pages: 12

DOI: 10.2174/2213111607666191003105654

Price: $65

Abstract

Background: A novel fault location method of HVDC transmission line based on a concentric relaxation principle is proposed in this paper.

Methods: Due to the different position of fault, the instantaneous energy measured from rectifier and inverter are different, and the ratio k between them is the relationship to the fault location d. Through the analysis of amplitude-frequency characteristics, we found that the wave attenuation characteristic of low frequency in the traveling wave is stable, and the amplitude of energy is larger, so we get the instantaneous energy ratio by using the low-frequency data. By using the method of wavelet packet decomposition, the voltage traveling wave signal was decomposed.

Results: Finally, calculate the value k. By using the data fitting, the relative function of k and d can be got, that is the fault location function.

Conclusion: After an exhaustive evaluation process considering different fault locations, fault resistances, and noise on the unipolar DC transmission system, four-machine two-area AC/DC parallel system, and an actual complex grid, the method presented here showed a very accurate and robust behavior.

Keywords: HVDC, fault location, concentric relaxation, instantaneous energy ratio, wavelet packet decomposition.

« Previous Next »
Graphical Abstract

[1]
F. da Silva, "Electric power systems (review of “HVDC Transmission: Power conversion applications in power systems)", IEEE Transactions on Industrial Electronics Magazine, vol. 4, no. 1, . pp. 75-76, 2010.
[http://dx.doi.org/10.1109/MIE.2010.936104]
[2]
W. An, M. Mou , and C.J. Wei, Reliability evaluation and comparison for different topologies of VSC-HVDC distribution networks using analytical and simulation methods..
[3]
S. Lan, M.J. Chen, and D.Y. Chen, "A Novel HVDC Double-terminal Non-Synchronous Fault Location Method based on Convolutional Neural Network", 2019
[http://dx.doi.org/10.1109/TPWRD.2019.2901594]
[4]
Z-Y. He, and L. Kai , X.P. Li, S. Lin, J.W. Yang, and R.K. Mai, , "Natural frequency-based line fault location in HVDC lines", IEEE Trans. Power Deliv., vol. 29, no. 2, . pp. 851-859, 2014
[http://dx.doi.org/10.1109/TPWRD.2013.2269769]
[5]
J. Ding, X. Wang, and Y. Zheng, "Distributed Traveling-wave-based fault-location algorithm embedded in multiterminal transmission lines", IEEE Trans. Power Deliv., vol. 33, no. 6, . pp. 3045-3054, 2018
[http://dx.doi.org/10.1109/TPWRD.2018.2866634]
[6]
G. Song, X. Chu, X. Cai, S. Gao, and M. Ran, "A fault-location method for VSC-HVDC transmission lines based on natural frequency of current", Int. J. Electr. Power Energy Syst., vol. 63, no. 24, . pp. 347-352, 2014.
[http://dx.doi.org/10.1016/j.ijepes.2014.05.069]
[7]
D. Spoor, "Improved single-ended traveling-wave fault-location algorithm based on experience with conventional substation transducers", IEEE Trans. Power Deliv., vol. 21, no. 3, . pp. 1714-1720, 2006
[http://dx.doi.org/10.1109/TPWRD.2006.878091]
[8]
D.W.P. Thomas, "Single ended travelling wave fault location scheme based on wavelet analysis", In: , Proc. 8th Inst. Elect. Eng. Int. Conf. Developments in Power System Protection, vol. 1, 2004, pp. 196-199.
[http://dx.doi.org//10.1049/cp:20040097]
[9]
X. Zeng, "Fault location using traveling wave for power net-works", Rec. IEEE Industry Applications Conf. 2004, pp. 2426-2429.
[10]
J. Sun, "Traveling wave fault location for power cables based on wavelet transform", In:, 2007 International Conference on Mechatronics and Automation, Harbin, China, 2007
[http://dx.doi.org/10.1109/ICMA.2007.4303734]
[11]
G. Donnici, L. Frizziero, D. Francia, A. Liverani, and G. Ca-ligiana, "TRIZ method for innovation applied to an hoverboard", Mech. Eng., 2018.
[http://dx.doi.org/10.1080/23311916.2018.1524537]
[12]
J. Suonan, "A novel fault-location method for HVDC transmission lines", IEEE Trans. Power Deliv., vol. 25, no. 2, . pp. 1203-1209, 2010.
[http://dx.doi.org/10.1109/TPWRD.2009.2033078]
[13]
J. Izykowski, "Accurate location of faults on power transmission lines with use of two-end unsynchronized measurements", IEEE Trans. Power Deliv., vol. 21, no. 2, . pp. 627-633, 2006.
[http://dx.doi.org/10.1109/TPWRD.2005.858778]
[14]
L. Yuansheng, "Time-domain fault-location method on HVDC transmission lines under unsynchronized two-end measurement and uncertain line parameters", IEEE Trans. Power Deliv., vol. 30, no. 3, . pp. 1031-1038, 2015
[http://dx.doi.org/10.1109/TPWRD.2014.2335748]
[15]
M. Farshad, "A Novel Fault-Location Method for HVDC Transmission Lines Based on Similarity Measure of Voltage Signals", IEEE Trans. Power Deliv., vol. 28, no. 4, . pp. 2483-2490, 2013
[http://dx.doi.org/10.1109/TPWRD.2013.2272436]
[16]
L. Frizziero, G. Donnici, and K. Dhaimini , "Advanced design applied to an original Multi-purpose ventilator achievable by additive manufacturing", Appl. Sci. (Basel), vol. 8, no. 12, . , pp. 2635, 2018
[http://dx.doi.org/10.3390/app8122635]
[17]
A. Liverani, "Design for Six Sigma (DFSS) for additive manufacturing applied to an innovative multifunctional fan", Inter. J. Interactive Design Manufacturing, vol. 8, no. 13, . pp. 309-330, 2019
[http://dx.doi.org/10.1007/s12008-019-00548-9]
[18]
C. Li, and P. He , "Fault-location method for HVDC transmission lines based on phase frequency characteristics", IET Gener. Transm. Distrib., vol. 12, no. 4, . pp. 912-916, 2018
[http://dx.doi.org/10.1049/iet-gtd.2017.0967]
[19]
J. Zaborsky, "Fast contingency evaluation using concentric relaxation", IEEE Trans. Power Apparatus Syst, vol. 99, no. 1, . pp. 28- 36, 1980.
[http://dx.doi.org/10.1109/TPAS.1980.319605]
[20]
Y.Q. Yang, "An analysis to the concentric relaxation phenomenon of power system forced oscillations", J. Sichuan Uni., vol. 45, no. 4, . pp. 163-170, 2013.
[21]
W.P Yao., "Multi scale permutation entropy analysis of electroencephalogram", Wuli Xuebao, vol. 63, no. 7, . pp.1-7, 2014.
[22]
V.P. Dardengo, P.A.H. Cavalcante, and M.C. de Almeida, "An evaluation of wave speed impacts on fault location methods for HVDC lines."In: 2018 IEEE PES Transmission & Distribution Conference and Exhibition-Latin America., T&D-LA, 2018, pp. 1-5.
[23]
J. Wang, X. Xiong, N. Zhou, Z. Li, and W. Wang, "Early warning method for transmission line galloping based on SVM and AdaBoost bilevel classifiers", IET Gener. Transm. Distrib., vol. 10, no. 14, . pp. 3499-3507, 2016.
[http://dx.doi.org/10.1049/iet-gtd.2016.0140]
[24]
J.M. Johnson, and A. Yadav , "Complete protection scheme for fault detection, classification and location estimation in HVDC transmission lines using support vector machines", IET Sci. Measur. Technol., vol. 11, no. 3, . pp. 279-287, 2017.
[http://dx.doi.org/10.1049/iet-smt.2016.0244]
[25]
C.S.L, "Data Fusion title of the article method of WAMS/SCADA hybrid measurements in power system state estimation", High Voltage Eng., vol. 39, no. 11, . pp. 2686-2691, 2013

Rights & Permissions Print Cite
Article Metrics
5
© 2024 Bentham Science Publishers | Privacy Policy